» Seeger-Rings to DIN 471/472
» Seeger-V-Rings
» Seeger-K-Rings
» Seeger-Rings to DIN 471/472, heavy-duty

Material:
Spring steel

Hardness:

Surface protection:
To manufacturer's choice
­ phosphated and oiled


Special versions Please enquire:

• self-finish and oiled
• galvanized
• bronze CuSn8
• corrosion-resistant steels

Please note:
The values in the data charts for the thickness s apply to phosphated, blackened or self-finish rings. If different surface coatings are required, these dimensions will be increased by the corresponding coating thickness.


Load bearing capacity calculation:
» more information

Standardization:
The data charts (DIN 471/472 "Standard version") and ("DIN 471/472 "Heavy-duty version") also include unstandardized dimensions.


Corrosion-resistant rings > 100 mm Please enquire:
For corrosion-resistant Seeger Rings to DIN 471/472 "Standard Version", rings consisting of the materials X10CrNi18-8, material No. 1.4310 or bronze CuSn8, material No. 2.1030, dimensions in excess of 100 mm nominal diameter, are manufactured only as circlips with assembly holes.

The thickness s=4 (+0,05 mm/-0,10 mm) and the width b=7,5-0,5 mm.
The unstressed diameter d3, the groove diameter d2 and the groove width values m correspond to those of the normal rings.
Rings with a thickness of 5 (+0,05 mm/-0,15 mm) consisting of corrosion-resistant steel can also be manufactured to a width of 12 mm. In this case, specify the material cross section 12x5 when ordering.


Assembly:
» more information

Seeger box Assortment:
Original Seeger-Rings stored ideally for the workshop and production shop in an indestructible plastic box. Clearly arranged, easy to remove and capable of being refilled, the box contains an assortment in the following sizes:


DIN 471 Shaft diameters 6 - 40 mm
DIN 472 Bore diameters 14 - 47 mm